Home
Question Bank
Notes
Aircraft
Career Guide
- Flight Attendant
- Pilot
- EASA
- LAME
- Resume writing
- Success Stories
- ATC

Question Bank

EASA Questions Mod 15: Gas Turbine Engine Set 22: Engine Storage

Question 1 - 5 of 15 (10 points each question)

1) Fuel system inhibiting oil is Report

mineral oil

kerosene

light anti-freeze oil

2) After placing an engine in an M.V.P envelope Report

check humidity indicator after 12 hours

check humidity indicator after 24 hours

check humidity indicator after 48 hours

3) On a vapour proof cocoon, there is a Report

humidifier

moisture indicator

temperature indicator

4) When an installed engine is not to be used for a period of up to 7 days Report

it is necessary to inhibit the engine

it is only necessary to blank off all apertures

run the engine as prescribed in the Flight Manual

5) Installed engines must be re-preserved after preservation at least every Report

six weeks

six days

six months

6) On storage of an engine, the desiccant is Report

looked at within 24 hrs if it's blue it's OK

looked at 24 hrs later if it's blue it's OK

looked at 24 hrs later if blue it should be replaced

7) After placing an engine into storage, details would be recorded in Report

Technical Log

Engine log book

Aircraft log book

8) When storing an engine the fuel system is to be inhibited. How is this done? Report

Remove plugs rotate engine then add oil

Rotate engine whilst adding oil then remove plugs

Add oil leaving plugs in

9) An engine in storage for 7 days should Report

have storage oil placed in engine

be run twice in that week

be fitted with covers and blanks and apertures covered

10) On a (VP) cocoon bag, if the humidity indicator turns pink/lilac Report

desiccant is effective and does not need changing

desiccant is ineffective and needs changing

desiccant is changed weekly

11) To inhibit the fuel system of an installed engine Report

dry motor the engine

remove the ignitor plugs

pump oil into the engine when stationary

12) When is the humidity indicator checked on a preserved engine? Report

1 Month

1 Year

6 Months

13) With an engine in storage, desiccant is used Report

as an insecticide

as a corrosion inhibitor

to remove moisture from the air

14) Small cuts in a M.V.P. engine storage bag can be repaired Report

by vulcanising

by replacing M.V.P

with adhesive PVC tape

15) When removing an engine for long-term storage, bleed valves should be Report

removed

locked closed

open but blanked

Sub Menu

Set 1: Fundamentals

Set 2: Engine Performance

Set 3: Engine Inlet

Set 4: Eng. compressors

Set 5: Combustion Section

Set 6: Turbine Section

Set 7: Engine Exhaust

Set 8: Bearing and Seals

Set 9: Lubricants and Fuel

Set 10: Lubrication system

Set 11: Fuel Systems

Set 12: Air Systems

Set 13: Ignition Systems

Set 14: Engine Indication

Set 15: Power Augmentation

Set 16:Turboprop engines

Set 17: Turboshaft

Set 18: APU

Set 19:Powerplant Installation

Set 20: Fire Protection

Set 21:Engine Monitoring

Set 22: Engine Storage

Please notify us via FAQ menu, if you find any wrong questions or need assistance in understanding and answering. We will attend to it immediately

Terms and Conditions | Privacy Policy | Contact Us
Copyright © 2024 Aerochapter.com | All rights reserved.